This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Cylinder sleeve protrusion

 Post Reply Post Reply
Author
Message
Kddrck View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 09 May 2021
Location: Paragould, Arka
Points: 37
Post Options Post Options   Thanks (0) Thanks(0)   Quote Kddrck Quote  Post ReplyReply Direct Link To This Post Topic: Cylinder sleeve protrusion
    Posted: 25 Jan 2022 at 12:08pm
I'm rebuilding the engine on a model C. We had to mill the top of the engine block. My question is how far above the block should the new cylinder protrude? 
Back to Top
Sponsored Links


Back to Top
steve(ill) View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: illinois
Points: 77236
Post Options Post Options   Thanks (0) Thanks(0)   Quote steve(ill) Quote  Post ReplyReply Direct Link To This Post Posted: 25 Jan 2022 at 12:29pm
.002 - .004 inch   .............. look close at the rods on the pistons.. They are offset as you install on the crank... two of them point different than the other two...



Like them all, but love the "B"s.
Back to Top
Kddrck View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 09 May 2021
Location: Paragould, Arka
Points: 37
Post Options Post Options   Thanks (0) Thanks(0)   Quote Kddrck Quote  Post ReplyReply Direct Link To This Post Posted: 25 Jan 2022 at 1:38pm
Thank you.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum