This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


170 lift arm cylinders

 Post Reply Post Reply
Author
Message
D17Milo View Drop Down
Bronze Level
Bronze Level


Joined: 11 Dec 2017
Location: Milo,Iowa
Points: 65
Post Options Post Options   Thanks (0) Thanks(0)   Quote D17Milo Quote  Post ReplyReply Direct Link To This Post Topic: 170 lift arm cylinders
    Posted: 21 Aug 2019 at 6:39pm
I have my lift arm cylinders removed, but I not sure how to take the apart to reseal them. Any help would be appreciated. Thanks
Back to Top
Sponsored Links


Back to Top
Joe(TX) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Weatherford. TX
Points: 1682
Post Options Post Options   Thanks (0) Thanks(0)   Quote Joe(TX) Quote  Post ReplyReply Direct Link To This Post Posted: 21 Aug 2019 at 6:58pm
It depends on which cylinder you have. Prior to SN 5019, the retainer cap screws in. It  has a rod smaller than the cylinder bore.
After that It used a full diameter ram that has a wire ring.
1970 190XT, 1973 200, 1962 D-19 Diesel, 1979 7010, 1957 WD45, 1950 WD, 1961 D17, Speed Patrol, D14, All crop 66 big bin, 180 diesel, 1970 170 diesel, FP80 forklift. Gleaner A
Back to Top
Pete from IL View Drop Down
Silver Level
Silver Level


Joined: 29 Dec 2009
Location: Beecher IL.
Points: 311
Post Options Post Options   Thanks (0) Thanks(0)   Quote Pete from IL Quote  Post ReplyReply Direct Link To This Post Posted: 22 Aug 2019 at 6:14am
If your cylinder has the full diameter ram then you have to take the fitting off of the cylinder barrel and extend the ram until you see the wire ring inside. Then take a screw driver and move the wire ring to the deeper groove in the ram and then you can take the ram all the way out.
Back to Top
D17Milo View Drop Down
Bronze Level
Bronze Level


Joined: 11 Dec 2017
Location: Milo,Iowa
Points: 65
Post Options Post Options   Thanks (0) Thanks(0)   Quote D17Milo Quote  Post ReplyReply Direct Link To This Post Posted: 22 Aug 2019 at 6:32am
Thanks Pete, I was just getting ready to ask how to find the ring. I removed the top seal and thought it would be self explanatory, but it wasn't.Smile
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.


Help Support the
Unofficial Allis Forum