Unofficial Allis Homepage
Forum Home Forum Home > Other Topics > Pulling Forum
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


226 wrist pins

 Post Reply Post Reply
Author
Message
PA185 View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 08 Mar 2019
Location: Pennsylvania
Points: 65
Post Options Post Options   Thanks (0) Thanks(0)   Quote PA185 Quote  Post ReplyReply Direct Link To This Post Topic: 226 wrist pins
    Posted: 02 Apr 2021 at 5:45am
For a 226 in a WD45 the wrist pins have to be offset one way or the other so they don’t rub the sleeves according to my manual.
It is the same way on the D17/170?
Also should the bolts on the rod that tighten down the wrist pin, should the bolts face away from or towards the cam? I have taken apart a couple of different engines and they were both opposite of each other. My manual also does not specify that so does it even matter?
Back to Top
Sponsored Links


Back to Top
SteveM C/IL View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Location: Shelbyville IL
Points: 6548
Post Options Post Options   Thanks (0) Thanks(0)   Quote SteveM C/IL Quote  Post ReplyReply Direct Link To This Post Posted: 14 Apr 2021 at 1:33pm
Been a while...think rods are offset (the beam is not centered over bearing) because of crank/block orientation....so it seems that 1&4 set one direction and 2&3 are opposite. If so 2 clamps will be on cam side and 2 opposite. The beam of rod is closer to cylinder wall on one side which is why the pin can't be centered in rod. You should be able to figure out which is correct after studying it. Don't clamp rod in vise to tighten wrist pin. Clamp one of those tapered/pointed hook bars in vise and stick wrist pin over it.
Back to Top
MACK View Drop Down
Orange Level
Orange Level


Joined: 17 Nov 2009
Points: 6975
Post Options Post Options   Thanks (0) Thanks(0)   Quote MACK Quote  Post ReplyReply Direct Link To This Post Posted: 30 May 2021 at 10:27pm
226, all bolts go to cam. Small engine B c D14 D15 ect. Two one way two the other.         MACK
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.062 seconds.


Help Support the
Unofficial Allis Forum