Construction and other equipment - I-600 ring gear with forks

Print Page | Close Window

I-600 ring gear with forks

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=72481
Printed Date: 28 Jun 2025 at 12:00am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: I-600 ring gear with forks

Posted By: WD45
Subject: I-600 ring gear with forks
Date Posted: 26 Jun 2013 at 6:12pm

Anyone change the ring gear in an I-600 with forks on the front.

Just finished taking the starter off and the drive plus casting on the end of the starter

was broken and some small pieces of the casting had fallen down.

Procedure for spliting to repair. thanks

Fred

-------------
Fred Dunlop, G,B,CA, WC,WF, 3 WD45`s,gas, diesel and LP,U,D10 series III, D12,D14,D15 SERIES II,D17 Series IV in Gas and Diesel ,D19 GAS and D21,170 185,210 ,220 an I-600 8070 fwd, 716H and 1920H

Replies:

Posted By: orangeman
Date Posted: 28 Jun 2013 at 7:51pm

I would think the ring gear would be the same as a D15 tractor. I bet that a ring gear to a 149 or 160 gas engine would work as well.

Procedure should be pretty straight forward. Pull cowl, radiator, stabilize tranny and torque tube.

Secure engine crane and attach engine lift to head, disconnect four engine bellhousing bolts and slide engine back.

Flywheel will be exposed. Order new ringgear heat and install let cool. Reverse process. An service manual would also be helpful.

Last please make sure you work safely. Good luck

Posted By: orangeman
Date Posted: 29 Jun 2013 at 8:45am

WD 45 sent you a PM. Let me know if you need additional information.

Long Live AC !!!