Farm Equipment - Clutch Job on D-14

Print Page | Close Window

Clutch Job on D-14

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=50760
Printed Date: 21 Aug 2025 at 11:54pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Clutch Job on D-14

Posted By: mherndon
Subject: Clutch Job on D-14
Date Posted: 18 May 2012 at 9:39am

I plan on taking the flywheel off to have it turned when I split the tractor to remove clutch. What are the torque specs for the following? Flywheel, pressure plate, and any other torques I might run into putting it back together?

Mark

-------------
D-15, Old dealer in Smithville, TN

Replies:

Posted By: CTuckerNWIL
Date Posted: 18 May 2012 at 12:06pm

http://www.imperialsupplies.com/pdf/A_FastenerTorqueCharts.pdf" rel="nofollow - http://www.imperialsupplies.com/pdf/A_FastenerTorqueCharts.pdf
You can look the bolt size up in this chart.

-------------
http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF

Posted By: JeffMOnt
Date Posted: 18 May 2012 at 12:28pm

Torque specs for flywheel is 75 Ft-lbs. Not sure on the pressure plate torque, but as Charlie stated you can look it up on the chart.

Posted By: Chalmersbob
Date Posted: 18 May 2012 at 10:02pm

presure plate is 17-20 ft lbs.

you can't always go by a universal chart. The spec in the book for a 3/8" head bolt on a G is 55 ft lbs. You will not find that on a bolt spec chart. Bob

Posted By: ironac
Date Posted: 20 May 2012 at 2:59am

Opps. I just cranked the bolts down on my d14 flywheel