190 trans oil going to axle housing
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=50617
Printed Date: 24 Aug 2025 at 5:33pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 190 trans oil going to axle housing
Posted By: DanWi
Subject: 190 trans oil going to axle housing
Date Posted: 15 May 2012 at 9:02pm
|
On my 190 the trans oil is filling the right axle housing causing the outside axle seal to leak and not keeping trans full. Was told its the axle cap can get to it by removing the pto housing (two speed pto) Any tips tricks or things to look for when I'm in there? Just replace the cap with some kind of sealer to keep it in place? |
Replies:
Posted By: DougG
Date Posted: 15 May 2012 at 9:17pm
| Thats what i done, not much to see other than the ring and pinion |
Posted By: DanWi
Date Posted: 15 May 2012 at 9:22pm
| Did you just replace the cap? and good to go. Wonder what makes them come out? old age mine has around 7000 hours. My tires are worn and when I'm empty on a hard dirt road in 7 or 8 gear I do geat a vibration, wonder if that would shake it loose? |
Posted By: DougG
Date Posted: 16 May 2012 at 4:15am
| Mine vibrates too in road gear, most do, if the cap looks good i just used silicone and glued it back, if it fits real loose u may consider gettng a different one or doing a little chisel work on it |
Posted By: DanWi
Date Posted: 16 May 2012 at 1:27pm
| Talking with a neighbor this morning about the problem, would medium strength loctite be what a person should use when installing the cap into the trans housing? |
Posted By: DanWi
Date Posted: 16 May 2012 at 11:48pm
| Took the pto housing off the back today cap was laying inside also the bolt that threads into the end of the axle, must have turned out and pushed the cap off. Good thing the axle didn't seem to be moving around. When cleaning the rear housing for reassembly found some small metal pieces, lower front bearing in the pto housing was close to failing, balls still in the bearing but the metal that keeps them in place was what I found in the bottom. So need to find a new bearing tomorrow. |
Posted By: CTuckerNWIL
Date Posted: 17 May 2012 at 7:00am
So maybe it was a good thing it started leaking before any Real damage was done internally
------------- http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |