ca progress/ #8 loader pics
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=4305
Printed Date: 03 Nov 2025 at 11:40pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: ca progress/ #8 loader pics
Posted By: caRon
Subject: ca progress/ #8 loader pics
Date Posted: 27 Nov 2009 at 8:25pm
  
Thought I'd try some pics of the ca I'm working on, and give a progress report. I have rebuilt the front end, the steering/gear box, hydraulic system and pump, fuel sytem/carb, cooling system, all new wiring, new gauges, new bat./ alt., added a 3pt. At the present I'm working on a ca #8 loader and snow blade. I plan on giving it a complete overhaul, rebuild the hand and foot clutch, new brakes, bearings, seals, and rubber. Then a correct paint job. I'm not tearing down the entire tractor all at once, I just keep one project going at a time.
   |
Replies:
Posted By: David Gantt N.C.
Date Posted: 27 Nov 2009 at 8:40pm
| sounds like your going to do her right, nice pictures thanks for sharing |
Posted By: caRon
Date Posted: 27 Nov 2009 at 9:01pm
| I'll also be looking for a set of rear wheel weights. What are they going for? Ron |
Posted By: Jim-Ohio
Date Posted: 28 Nov 2009 at 9:10am
| Ron, Where are you located? I would like to find a loader like that for my CA. I just gave $300 for a set of rear CA weights at the Wapak, Ohio swap meet. I would also like to hear what all was involved in rebuilding your hydraulic pump. |
Posted By: caRon
Date Posted: 28 Nov 2009 at 10:32am
|
Jim, I'm in MO, but will be moving to IN soon. I'll keep an eye out for a #8 loader for you. The hardest thing about rebuilding the hyd pump is keeping track of your parts.
Have a parts diagram with you. It's a pretty easy rebuild, make sure everything is clean. I soaked the pump in solvent then sprayed it out with brake parts cleaner and compressed air. Inspect parts for wear. I replaced all the springs, balls, seals, o-rings, ect.. I have a parts list with prices if you need it. While the pto housing is open clean all the grud out, pull the side cover off the trans. and do the same. I fill it with a good hyd/trans fluid. If you need anything email me I'll be glad to help. Ron
|