Drag disk to SC disk
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=41557
Printed Date: 28 Aug 2025 at 11:07am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Drag disk to SC disk
Posted By: Josh Day
Subject: Drag disk to SC disk
Date Posted: 04 Dec 2011 at 8:49am
| I was wondering if there is any way to convert an old drag type disk to a snap coupler lift disk to pull behind a CA. Does any one have any pics of one? Or is this even possible? Thanks Josh. |
Replies:
Posted By: steve(ill)
Date Posted: 04 Dec 2011 at 9:20am
|
It would be easy enough to put the eye and beam onto the old disc, but your lift arms grab a rigid frame of the disc to raise it. Lot of old pull discs dont have much of a frame and are kind of floppy in the center. You would need a disc that had a rigid angle iron frame all around it. ------------- Like them all, but love the "B"s. |
Posted By: stray
Date Posted: 04 Dec 2011 at 9:21am
|
The one AC drag type disk that I was around I would say "No way." It would have been a load on a CA anyway. If I remember right it was about 8' wide and pivoted in the middle, You had to set both the front and rear halfs to the disired cut angle. I don't know if all the drag type disk that Allis made was this way or not. ------------- 1969 190XT series 3 |
Posted By: Rfdeere
Date Posted: 04 Dec 2011 at 5:22pm
I don't think Josh is talking about using an Allis Drag Disk. ------------- Randy Freshour,Member Indiana AC Partners, http://www.rumelyallis.com" rel="nofollow - http://www.rumelyallis.com |
stray wrote:Posted By: powertech84
Date Posted: 04 Dec 2011 at 6:28pm
| I dont think it would be to bad of a job to convert a new compact utility type three point disk to work. I'm thinking like a king cutter, or frontier brand 4-5 ft rig. |
Posted By: Josh Day
Date Posted: 04 Dec 2011 at 8:04pm
No, any brad of drag disk. I was just thinking of mabey a later project if its not that hard to do. |