Construction and other equipment

Print Page | Close Window

6g injector pump

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=25367
Printed Date: 18 Jul 2025 at 9:32pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 6g injector pump

Posted By: hindu
Subject: 6g injector pump
Date Posted: 07 Feb 2011 at 7:45am

My 6g went to running wide open no matter what position the throttle is in even disconnected running it by hand at the injector pump it runs wide open anyone have this happen? Any help would be appreciated.

Replies:

Posted By: gemdozer
Date Posted: 07 Feb 2011 at 12:14pm

You should have a broken rod or spring in governor control

Posted By: hindu
Date Posted: 08 Feb 2011 at 5:50am

I took the injector pump off and took it apart there is a very small nipple on the end of a shaft below the injector head that is broken/worn off would you happen to have a parts breakdown for this? Thanks for any help you could give. Thanks for the reply.

Posted By: gemdozer
Date Posted: 08 Feb 2011 at 2:34pm

I just check and remove the small cover with 2 screws and the shaft is in good condition with a spring and a nippe at the end and in the inside cover CV9018

mailto:gemdozer@hotmail.com - gemdozer@hotmail.com

Posted By: hindu
Date Posted: 08 Feb 2011 at 8:37pm

Thanks. I just sent you an e-mail.