AC 1300 FC wheel hub
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=211346
Printed Date: 12 Oct 2026 at 1:59pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: AC 1300 FC wheel hub
Posted By: dnel45
Subject: AC 1300 FC wheel hub
Date Posted: 13 Jun 2026 at 7:29am
| Had a bearing go out and it trashed the hub out pretty good, cleaned it up but new bearings are sloppy in it. Anyone have a good used hub around? Agco wants $589 for one. |
Replies:
Posted By: IBWD MIke
Date Posted: 13 Jun 2026 at 7:31am
|
I might have a couple from a 1200, likely the same. Will look today.
Edit; Since I have developed the habit of posting and forgetting, put my shoes on and went for a walk. I do have one, missing the bearing cap but they aren't hard to find. Took a couple pictures, call/text me, 641-521-3575, Mike.
|
Posted By: Ed (Ont)
Date Posted: 13 Jun 2026 at 8:01am
| Can you peen the hub to get you going?? I have done that to hubs if not too badly worn! May help for a while. |
Posted By: PaulB
Date Posted: 13 Jun 2026 at 3:23pm
|
Look into generic wagon hubs. AC wasn't one to design a specific part if something off the shelf would suit. ------------- If it was fun to pull in LOW gear, I could have a John Deere. Real pullers don't have speed limits. If you can't make it GO... make it SHINY |
Posted By: Daehler
Date Posted: 13 Jun 2026 at 8:22pm
|
I have some ------------- 8070FWA,7080 BlackBelly, 7045,2 200s,D19,D17,G, WD,45,UC,7 AC mowers and lots more! "IT TAKES 3 JD's TO OUT DO AN ALLIS, 2 TO MATCH IT IN THE FIELD AND 1 FOR PARTS!" |
Posted By: dnel45
Date Posted: 13 Jun 2026 at 8:43pm
| Hey Mike thanks for checking - is it a 6 bolt hub? |
Posted By: IBWD MIke
Date Posted: 14 Jun 2026 at 9:50am
No, mine are 4-bolt.
|
dnel45 wrote:Posted By: AC7060IL
Date Posted: 17 Jun 2026 at 7:11am
| dNel45, try using a sharp center punch to divot the hub’s inner housing. Punch ever 1/2 inch inside the hub’s bearing housing to decrease its inner diameter, then press in new bearing races. |
Posted By: Ed (Ont)
Date Posted: 17 Jun 2026 at 7:53am
Yes exactly what I suggested. Also Permatex has a race retaining product that helps. I have used it. Will try to get a picture for you. Have some in shop.
|
Posted By: SteveM C/IL
Date Posted: 17 Jun 2026 at 7:19pm
| Center punch and red loctite works pretty good. |