Farm Equipment - WD hand cultch removal

Print Page | Close Window

WD hand cultch removal

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=211287
Printed Date: 30 Sep 2026 at 9:35am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: WD hand cultch removal

Posted By: 19F150
Subject: WD hand cultch removal
Date Posted: 06 Jun 2026 at 4:00pm

How do you remove hand cultch assembly?

Replies:

Posted By: DrAllis
Date Posted: 06 Jun 2026 at 6:18pm

Battery box has to be removed and then the tractor split apart about 8 inches right there. Hand clutch comes up and out the hole directly underneath the battery box.

Posted By: Gary
Date Posted: 06 Jun 2026 at 6:23pm

Page 34 in Part 1 of the Allis WD Service Manual gives a good explanation.

G

Posted By: 19F150
Date Posted: 06 Jun 2026 at 9:52pm

how do you get the handclutch housing apart from the transmison

Posted By: DrAllis
Date Posted: 06 Jun 2026 at 10:03pm

Remove three 1/2" bolts on each side of the torque housing probably covered in dirt/grease. Remove two side frames bolts at the rear of each side frame. Brake pedal rods and springs disconnect. Steering wheel post disconnect from the transmission shift cover. PTO push/pull lever remove. Traction Booster signal linkage remove. Hand clutch clevis pin remove. That's about it I think. Roll the rear end away from the front. Use jacking under the PTO box. Use long redi-bolt thru the side frames ears to keep things under control. Why are you removing the hand clutch ??

Posted By: 19F150
Date Posted: 07 Jun 2026 at 10:25pm

have all bolts removed and toque tube still won't come off from transmission

Posted By: DrAllis
Date Posted: 07 Jun 2026 at 10:50pm

Have you got the PTO shaft removed from the tractor ??

Posted By: 19F150
Date Posted: 08 Jun 2026 at 7:16am

PTO shaft is off. torque moved about 1/4 inch is all

Posted By: DrAllis
Date Posted: 08 Jun 2026 at 7:20am

Hand clutch released?? or still locked in ? The bottle jack under the PTO box might have to be raised or lowered just a tick. You might be on a bind.

Posted By: HudCo
Date Posted: 08 Jun 2026 at 8:44am

is nt their a bolt inside the trans

Posted By: LaJaMe
Date Posted: 17 Jun 2026 at 9:38pm

As Dr Allis Says, Neewd to support the middle of the tractor.