D17 series 4 Hydraulic line
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=209402
Printed Date: 19 Dec 2025 at 10:03am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D17 series 4 Hydraulic line
Posted By: Don(MI)
Subject: D17 series 4 Hydraulic line
Date Posted: 17 Dec 2025 at 7:27pm
Well I sure did it good today, got the idiot award. Even on D17 day! Ugh....Played with the spool adjustments, screwed the right spool in about 3 turns and heard "POP".....Blew the smaller Hydraulic line coming from the pump that wraps under the bell housing then runs down left side under foot board. Question- is there even a good way to take it off without too much trouble? Looks like I need to pull off the seat and bracket, and even drop the Left Hydraulic Ram? Line looks like it's 10 ft. Long. Might attempt to braze it shut again, I can't imagine a shop could bend a new 1 and get it right? She's gotta have 50 bends in it.
-------------
Galatians 5:22-24
"I got a pig at home in a pen and corn to feed him on, All I need is a pretty little girl to feed him when I'm gone!"
|
Replies:
Posted By: SteveM C/IL
Date Posted: 17 Dec 2025 at 7:46pm
|
Why were you messing with that and why 3 turns? Seems like too much! Consider yourself lucky if you didn't split the pump housing.Watch out for this one...guy turns relief in cause the old pump is worn out. Finally gives in and replaces pump but doesn't back off relief....POP! goes the pump hsg.
|
Posted By: Don(MI)
Date Posted: 17 Dec 2025 at 8:26pm
Thanks! Hey the housing is good.
-------------
Galatians 5:22-24
"I got a pig at home in a pen and corn to feed him on, All I need is a pretty little girl to feed him when I'm gone!"
|
|