190XT pto
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=207751
Printed Date: 15 Aug 2025 at 10:25pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 190XT pto
Posted By: TedN
Subject: 190XT pto
Date Posted: 11 Aug 2025 at 12:58am
I tried using my recent purchase 190XT SeriesI today and found a pto failure. I knew when I bought it that it had a pto issue, seller thought it was control linkage. I got the detent freed up on the linkage for the hydraulic clutch and assumed I had fixed the linkage issue. Hooked it to a baler, no pto. After a few choice words and unhooking the baler I remembered that they have the mechanical disconnect on the left side, so I crawled underneath and checked. Sure enough lever was down. Pushed it back up, hooked up baler and got about quarter of a revolution, lever dropped to disengage position again. I assume it uses the same detent as the no clutch models, is it possible to have a weak spring in the detent or is it likely I have issues inside? It didn't take much effort to shift it. Any thoughts and/or advice is appreciated.
Ted
-------------
190XTD seriesIII, 190XTD seriesI, maroon belly 7000, 190XTD series??? project(or maybe parts)
|
Replies:
Posted By: DrAllis
Date Posted: 11 Aug 2025 at 6:37am
|
I'm thinking it isn't going 100% into full engagement. From the full OFF position to full ENGAGED position would be 45 degrees of travel on that lever. Not 25 or 30 degrees, but 45 degrees. If the front end of the rear PTO shaft is burred up or has any kind of damage or twist to it, that will keep you from engaging fully.
|
Posted By: TedN
Date Posted: 11 Aug 2025 at 12:48pm
I think you are correct, it went from angled down slightly to pointing straight back. It will probably be a few days before I get back to it, baling alfalfa at the other farm plus the full time job. Thank you for the input.
Ted
-------------
190XTD seriesIII, 190XTD seriesI, maroon belly 7000, 190XTD series??? project(or maybe parts)
|
|