Farm Equipment - moniter

Print Page | Close Window

moniter

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=185667
Printed Date: 18 Oct 2025 at 12:51pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: moniter

Posted By: Ilikeallis
Subject: moniter
Date Posted: 10 Jan 2022 at 10:44am

I have a moniter for allis 330 6 row air 78 units, that seems to flash all the time even when a chain broke on 1 row and i continued planting because it kept flashing, but then somrtimes it goes blank for a few seconds, open for suggestions, or opinions, thanks

Replies:

Posted By: jaybmiller
Date Posted: 10 Jan 2022 at 10:50am

while I don't know your equipment....

bad wiring and or connections would be my first 2 guesses.

gotta be a a fair bit of 'vibration' going on and that's always bad for connectors. Bend a wire enough times ,it'll break.

any water(? hehe) or chemicals, that WILL corrode wires, might not even see that happen

-------------
3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor)

Never burn your bridges, unless you can walk on water

Posted By: DrAllis
Date Posted: 10 Jan 2022 at 11:33am

Sounds like some serious 2-person testing is needed. Somehow turning each seed disc individually with seed in the hopper and fans running. Row #1 should align with Light #1 and so on. No other light should flash when testing one row at a time. There should be a beeper alarm when things quit planting, so it must not work either. Sounds like a harness issue to me. Dickey John made the monitor for A-C.

Posted By: tbran
Date Posted: 10 Jan 2022 at 11:10pm

hook all up, unplug all the units - drive around or at least wiggle the harness at all points. No light should be on or flash, then plug in one by one doing the same thing - should eliminate the harness or a sensor. Another troubleshooting trick is to see what light is on - then swapping the row next to it to see if the problem follows the sensor or stays with the harness.

-------------
When told "it's not the money,it's the principle", remember, it's always the money..