Construction and other equipment - G-153 parts for FP40 forklift

Print Page | Close Window

G-153 parts for FP40 forklift

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=180766
Printed Date: 25 Aug 2025 at 6:58am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: G-153 parts for FP40 forklift

Posted By: meddleshop
Subject: G-153 parts for FP40 forklift
Date Posted: 26 May 2021 at 9:14am

New member here, I'm having a hard time finding gaskets for a G-153 engine. I need the exhaust gasket but would happily buy a top end set, whatever it takes to quiet this thing down! I searched the web and tried to go through my local NAPA but had no luck. Any help appreciated

Replies:

Posted By: jaybmiller
Date Posted: 26 May 2021 at 10:20am

same BUDA engine as in a Cockshutt 30 tractor.

I think Steiner's has stuff for them....

Jay

-------------
3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor)

Never burn your bridges, unless you can walk on water

Posted By: meddleshop
Date Posted: 26 May 2021 at 2:10pm

Thanks for the reply, problem is the gaskets they show on these sets must be a cross flow head, mine has old fashioned siamese manifold with individual gaskets for each port.

these sets that are offered show separate intake and exhaust gaskets with 4 ports each. Maybe I should just buy it and cut into pieces.......

Posted By: meddleshop
Date Posted: 26 May 2021 at 2:22pm

thanks again, I just figured it out. I looked at the replacement manifold for the cockshutt and they sell the combo gasket seperately. Better picture of the gasket.

Posted By: meddleshop
Date Posted: 22 Jun 2021 at 7:22pm

I got the engine fixed, the gasket I got from Steiners wasn't correct butI was able to modify it to fit my machine. The end ports on my engine are round and the gasket came with rectangular ports on the ends only. I cut the gasket into 3 pieces so I could move the ends over enough to sort of match the round ports and punched new bolt holes. worked just fine, running good now.