D15 II Exhaust Manifold
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=178452
Printed Date: 23 Aug 2025 at 10:31pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D15 II Exhaust Manifold
Posted By: modirt
Subject: D15 II Exhaust Manifold
Date Posted: 19 Feb 2021 at 8:30am
|
If a guy needed to replace one of those, are they available? AGCO parts book appears to have a very limited supply. Call Brenda? Other?
|
Replies:
Posted By: ACinSC
Date Posted: 19 Feb 2021 at 11:29am
| Dunno about a series 2 but I got one for my series 1 from Brenda ? |
Posted By: DiyDave
Date Posted: 19 Feb 2021 at 5:28pm
When in doubt, call Brenda first! ------------- Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need! |
Posted By: DSeries4
Date Posted: 20 Feb 2021 at 9:34am
|
Only Series 1 manifolds are available. Then you get the outlet threaded to accept a 1" pipe nipple (4" in length). Put bolts in to fill the holes for the series 1 muffler. I went through this less than a year ago. ------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |
Posted By: modirt
Date Posted: 22 Feb 2021 at 1:26pm
|
Looks like I may have to get up to speed on conversion of a series I.......the "mighty Sandy Lake Brenda" has struck out! Out of curiosity, how hard is it to do new castings? Seems like the hard part would be doing the tooling, but if a pristine manifold could be found, seems like the casting part from there ought to be relatively straight forward.
|
Posted By: PaulB
Date Posted: 22 Feb 2021 at 2:32pm
|
The only difference between a series I and series II is a no threaded hole vs a threaded hole. Just get a series I and tap the pipe threads. Getting solid castings is one thing, those with inside passages is quite another ------------- If it was fun to pull in LOW gear, I could have a John Deere. Real pullers don't have speed limits. If you can't make it GO... make it SHINY |
Posted By: DSeries4
Date Posted: 22 Feb 2021 at 8:30pm
|
Series I manifold...  Turned into a Series II manifold...  Again, thread the outlet and put a couple of bolts in to plug the series I muffler holes. Once the hood panel is on, no one will know! ------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |