Tools needed to adjust the clutch on a D series
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=173869
Printed Date: 05 Sep 2025 at 5:11pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Tools needed to adjust the clutch on a D series
Posted By: T-bone_indy
Subject: Tools needed to adjust the clutch on a D series
Date Posted: 27 Aug 2020 at 7:19am
 I had to be creative... Also patients and holding your tongue in the right position help 
------------- D19-AC916-Kubota B2150- Wheel Horse charger 12 |
Replies:
Posted By: chaskaduo
Date Posted: 27 Aug 2020 at 9:36am
 ------------- 1938 B, 79 Dynamark 11/36 6spd, 95 Weed-Eater 16hp, 2010 Bolens 14hp |
Posted By: T-bone_indy
Date Posted: 27 Aug 2020 at 10:18am
|
Thank you! ------------- D19-AC916-Kubota B2150- Wheel Horse charger 12 |
Posted By: chaskaduo
Date Posted: 27 Aug 2020 at 11:11am
|
Your picture came up way large 1st time I viewed the post, now it comes up only 25% larger than mine. I also did a update to my windows in between. A lot of times the guys have troubles getting their pictures down to size. ------------- 1938 B, 79 Dynamark 11/36 6spd, 95 Weed-Eater 16hp, 2010 Bolens 14hp |
Posted By: ACinSC
Date Posted: 27 Aug 2020 at 1:02pm
| Thanks for posting this Terry . I may have to resort to something similar . I'm guessing this is adjust the clutch fingers through the inspection hole ? |
Posted By: garden_guy
Date Posted: 27 Aug 2020 at 2:54pm
|
Whoo. I don't have a D17, but this looks like an awful pain in the rear. What's the procedure? |
Posted By: T-bone_indy
Date Posted: 27 Aug 2020 at 7:03pm
|
No problem AC, so far then I had to bump the engine over to catch the fingers in different positions. Good luck hope this helps ------------- D19-AC916-Kubota B2150- Wheel Horse charger 12 |
Posted By: T-bone_indy
Date Posted: 27 Aug 2020 at 7:06pm
|
I know what up proctologist feels like.. Hahaha there's about a 2 inch diameter hole on the bell housing where you try to reach a 7/16 bolt. Trying to adjusted Each finger quarter-inch off the of throw out bearing ------------- D19-AC916-Kubota B2150- Wheel Horse charger 12 |
Posted By: ACinSC
Date Posted: 27 Aug 2020 at 8:01pm
| Thanks again Terry . Hope to have my D 15 together and running soon . Then I'll decide if I have to adjust mine . |