Farm Equipment - 200 power director

Print Page | Close Window

200 power director

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=162330
Printed Date: 20 Aug 2025 at 11:06pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 200 power director

Posted By: 200Tom1
Subject: 200 power director
Date Posted: 29 Jun 2019 at 5:02pm

Fellows. I think I need to drill the hole in the linkage as stated in the book. I do have a copy of the AC service manual. But it is a copy and the picture is not good. Would anyone be able to post a picture of the linkage where the hole needs to be drilled? My manual shows the measurements I need to use to drill the hole but not the piece of metal that's needs the hole. Thank you for your help.

Replies:

Posted By: DrAllis
Date Posted: 29 Jun 2019 at 5:05pm

You basically drill a new hole forward of the existing hole with 1/8" of metal left between the two holes. YOU WILL HAVE TO GRIND/TORCH above this area to eliminate rubbing of the vertical rod when you get done.

Posted By: 200Tom1
Date Posted: 29 Jun 2019 at 8:50pm

I think I figured out which rod/ linkage it is. Do I need to tear this linkage completely out to drill the hole? Are we looking at hours to do this? Like I said the book I have is a copy and pictures are bad. Again thank you guys.

Posted By: Dave H (NE)
Date Posted: 29 Jun 2019 at 9:07pm

no remove the pin on the valve and the vertical rod, then turn the linkage down to drill it.

Posted By: 200Tom1
Date Posted: 30 Jun 2019 at 2:47pm

Thanks guys. Gonna do this tomorrow evening.