D17 Front Support Picture
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=158900
Printed Date: 11 Aug 2025 at 9:43am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D17 Front Support Picture
Posted By: tractorboy
Subject: D17 Front Support Picture
Date Posted: 09 Mar 2019 at 2:41pm
D17 front support seems to be wallowed out. Not sure how much build it up. Anyone have a picture or measurement would be helpful? I am guessing if too tight it will be hard to put back. Thanks, Keith
|
Replies:
Posted By: DrAllis
Date Posted: 09 Mar 2019 at 5:00pm
| Surely the pin that goes into that hole is worn out too ??? |
Posted By: Pat the Plumber CIL
Date Posted: 09 Mar 2019 at 8:33pm
|
Doc , can that be bored , machined , drilled out and have a bushing installed ? And yes then have the other end built up . ------------- You only need to know 3 things to be a plumber;Crap rolls down hill,Hot is on the left and Don't bite your fingernails 1964 D-17 SIV 3 Pt.WF,1964 D-15 Ser II 3pt.WF ,1960 D-17 SI NF,1956 WD 45 WF. |
Posted By: DrAllis
Date Posted: 09 Mar 2019 at 10:32pm
| It may need to be welded up some and then bored and then a bushing installed. All depends how bad it is. |
Posted By: tractorboy
Date Posted: 10 Mar 2019 at 1:12am
| Makes no sense but the pin didn't wear much at all. thanks |
Posted By: Clay
Date Posted: 11 Mar 2019 at 9:43am
|
Not a problem. The hole on our D-17 was in the same condition as the one in the photo. Over 20 years ago, I rebuilt it with Belzona 1111 (Super Metal) and a new bushing. Replaced the worn out pivot pin with new pivot pin. This tractor has a 500 loader. Most of the time, it is used to move round bales.
|