Print Page | Close Window

Rebuilt Gleaner Governors?

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=153309
Printed Date: 19 Nov 2025 at 2:14pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: Rebuilt Gleaner Governors?
Posted By: KeepItSimple
Subject: Rebuilt Gleaner Governors?
Date Posted: 24 Aug 2018 at 10:52am
I have a Gleaner K2 combine with the GM250 motor and the governor shaft bearings are sounding pretty rough. It needs to be rebuilt or replaced. Used ones out of the bone yard seem to be about the same condition and also need to be rebuilt. 

Does anyone rebuild these old OEM gleaner governors from the GM250? I think the biggest challenge may be removing the pulley from the shaft to get to the bearing and oil seal.

Does anyone sell aftermarket governors that are a direct match to this one without significant modification? The AGCO part# is 71188609. They are discontinued from AGCO. 

I'd like to just swap this one out with a rebuilt or aftermarket that bolts right in without screwing around with new linkage pins/rods.

Any guidance would be appreciated.



Replies:
Posted By: CAL(KS)
Date Posted: 24 Aug 2018 at 11:24am
i dont have any knowledge on the Gm 250 or its governor but new belt drive governors are available and im guessing the gm uses that style?

-------------
Me -C,U,UC,WC,WD45,190XT,TL-12,145T,HD6G,HD16,HD20

Dad- WD, D17D, D19D, RT100A, 7020, 7080,7580, 2-8550's, 2-S77, HD15


Posted By: tbran
Date Posted: 25 Aug 2018 at 10:21pm
http://hoofgovernors.com/   not" rel="nofollow - http://hoofgovernors.com/   not to be confused with https://en.wikipedia.org/wiki/Benjamin_Pierce_" rel="nofollow - https://en.wikipedia.org/wiki/Benjamin_Pierce_ (governor) :-)

-------------
When told "it's not the money,it's the principle", remember, it's always the money..


Posted By: PaulB
Date Posted: 26 Aug 2018 at 2:16pm
I have one of those belt driven governors that I would sell. It was brought new to put on a V8 that we had in a Farmall M that we were farming with. Send me a PM with your email address and I can send you some pictures.

-------------
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net