AC 7000 clutch safety switch
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=140166
Printed Date: 18 Jul 2025 at 3:43pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: AC 7000 clutch safety switch
Posted By: EDD
Subject: AC 7000 clutch safety switch
Date Posted: 06 Jul 2017 at 10:54am
|
Anyone know where the clutch safety switch is located. I know it has to be somewhere in the clutch linkage! Was wondering if'n I have to remove the fuel tank to get to it? Thinking about by-passing the switch. Any helpful instructions would be appreciated? Looking up under the tractor I cannot seem to locate it?
|
Replies:
Posted By: Dans 7080
Date Posted: 06 Jul 2017 at 10:55am
Should be under the dash.
-------------
When someone tells you Nothings Impossible, Tell them to slam a revolving door
|
Posted By: DrAllis
Date Posted: 06 Jul 2017 at 11:01am
|
Under the floor mat just inside the cab door about 10 inches. There's also one on the PTO valve behind the batteries.
|
Posted By: EDD
Date Posted: 06 Jul 2017 at 11:07am
|
you saying it is NOT on the clutch linkage under the cab? Woulda thought it has to be connected to the linkage?
|
Posted By: EDD
Date Posted: 06 Jul 2017 at 11:12am
|
i'm having to depress the clutch 15-20 times to get it to roll. Assuming this IS the switch problem? I suppose I can pull the wires and tie them together and eliminate the switch? Can that be done thru the floor panel?
|
Posted By: DrAllis
Date Posted: 06 Jul 2017 at 11:17am
|
I'm saying it is under the floor mat, under the cab floor, underneath an access cover in the floor and yes, the clutch pedal rod touches the end of the switch.
|
Posted By: EDD
Date Posted: 06 Jul 2017 at 11:22am
|
thanks, will check it out
|
Posted By: DougG
Date Posted: 06 Jul 2017 at 1:25pm
|
If you mean roll, as in engine roll over to start???????? The switch will be adjustable with 2 nuts , just move it down to get the switch to make contact if you still want it
|
Posted By: Ron(AB)
Date Posted: 06 Jul 2017 at 1:46pm
Yes, that switch needs to be adjusted as the linkage wears… I've done mine years back.
If you look behind the fuel tank under the firewall of the cab you should see it.
|
|