190xt series 3 diesel high/low question
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=137022
Printed Date: 08 Nov 2025 at 1:49pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 190xt series 3 diesel high/low question
Posted By: rudyk
Subject: 190xt series 3 diesel high/low question
Date Posted: 04 Apr 2017 at 8:37pm
I have a 190xt, it doesnt seem to want to run on the high side.
Pulls great on the low side, when I put it high it will pull but doesnt seem like it is fully engaging. I checked to see if the likage was sloppy, though it seemed it was fully in gear I pulled up on the linkage under the platform to check.
Any advice is appreciatied.
|
Replies:
Posted By: MACK
Date Posted: 04 Apr 2017 at 9:06pm
|
If linkage is all good and adjusted to where it is moving spool all the way, may have a bunch of broken plates on hi side. MACK
|
Posted By: Lonn
Date Posted: 05 Apr 2017 at 6:47am
Had the high side fail on my 200 (actually bought it that way a year ago). Had an local former AC dealer, now repair shop and auctioneer, do the repair. At $75/hour came to $2000. That included another split to repair a leak on the clutch shaft in the bell housing. Needed all new plates on the high side. Without the second split I'm guessing it would be around $1,500 or so just so you have an idea of possible cost.
-------------
-- --- .... .- -- -- .- -.. / .-- .- ... / .- / -- ..- .-. -.. . .-. .. -. --. / -.-. .... .. .-.. -.. / .-. .- .--. .. ... -
Wink
I am a Russian Bot
|
|