Farm Equipment - Gleaner E and All cylinder

Print Page | Close Window

Gleaner E and All cylinder

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=131629
Printed Date: 31 Oct 2025 at 12:58am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Gleaner E and All cylinder

Posted By: Carl(NWWI)
Subject: Gleaner E and All cylinder
Date Posted: 21 Nov 2016 at 10:03am

Been doing some research trying to find new cylinder bars for the E and A2 but I'm not coming up with anything short of calling an AGCO dealer. Are there any aftermarket suppliers that still offer them? Does AGCO still offer them? Looking to do corn, beans, oats, wheat and rye with them.

Thanks. Carl

Replies:

Posted By: DrAllis
Date Posted: 21 Nov 2016 at 10:07am

E-E3-K-K2 are all the same. The A-A2 is an orphan.

Posted By: Skyhighballoon(MO)
Date Posted: 21 Nov 2016 at 10:08am

Google Trimpe Hard Surface Bars and St. Johns Welding. Mike

-------------
1981 Gleaner F2 Corn Plus w 13' flex
1968 Gleaner EIII w 10' & 330
1969 180 gas
1965 D17 S-IV gas
1963 D17 S-III gas
1956 WD45 gas NF PS
1956 All-Crop 66 Big Bin
303 wire baler, 716H, 712H mowers

Posted By: Tbone95
Date Posted: 21 Nov 2016 at 10:48am

I bet St. Johns would make something for you. Even if you had to send in an old one (which I doubt you would).

Posted By: Carl(NWWI)
Date Posted: 21 Nov 2016 at 12:20pm

So the A uses different ones then the E and K?

Posted By: SteveM C/IL
Date Posted: 21 Nov 2016 at 12:51pm

The A/A2 cyl is wider than E-K's

Posted By: DrAllis
Date Posted: 21 Nov 2016 at 12:54pm

The A-A2 had three wide straw walkers. The C-C2 had four wide straw walkers. These two machines were based off of each other so to speak. The E-E3-K-K2 also had three walkers, but there were an inch or two narrower.

Posted By: MACK
Date Posted: 21 Nov 2016 at 9:29pm

I have a set for A-A2 that I cut ever other tooth out then built back up that I would sell cheap. Went to F2. MACK