Farm Equipment - Wd flywheel

Print Page | Close Window

Wd flywheel

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=130073
Printed Date: 06 Jun 2025 at 3:37am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Wd flywheel

Posted By: dougsiefert
Subject: Wd flywheel
Date Posted: 16 Oct 2016 at 7:35am

I'm putting my WD back together after replacing the ring gear on the flywheel. The flywheel seems to only want to line up on the crank in a certain position, Is this the right spot or do I need to find tdc. and line up the timing mark like my book says. I'm afraid that I might install it 180 out. Any advice.

Replies:

Posted By: Rick
Date Posted: 16 Oct 2016 at 8:21am

It only goes on one way...can't mess that up! Rick

Posted By: Allis dave
Date Posted: 17 Oct 2016 at 7:05am

Just installed mine last night too! Only goes on one way. Good job Allis engineers

Posted By: Don(MO)
Date Posted: 17 Oct 2016 at 8:59am

Before removing the WD flywheels paint one of the bolt holes on the flywheel and crankshaft and then install two studs in the crankshaft for alignment makes installing that heavy flywheel a lot faster, no turning the flywheel around on the shaft.

-------------
3 WD45's with power steering,G,D15 fork lift,D19, W-Speed Patrol, "A" Gleaner with a 330 corn head,"66" combine,roto-baler, and lots of Snap Coupler implements to make them work for their keep.