HD5 serial number location
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=152091
Printed Date: 29 Apr 2024 at 5:43am Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: HD5 serial number location
Posted By: dyno
Subject: HD5 serial number location
Date Posted: 14 Jul 2018 at 6:29pm
Where is the S/N stamped on my HD5 Dozer? I looked on top of the back housing by the steering clutch cover but can’t see it.
|
Replies:
Posted By: truckerfarmer
Date Posted: 14 Jul 2018 at 10:01pm
It is on the back of the housing,cnot the top. You were within inches of it.
------------- Looking at the past to see the future. '53 WD, '53 WD45, WD snap coupler field cultivator, #53 plow,'53 HD5B dozer
Duct tape.... Can't fix stupidity. But will muffle the sound of it!
|
Posted By: Coke-in-MN
Date Posted: 14 Jul 2018 at 10:51pm
Left rear case on back side of casting about 1" down from top , if it is a HD5G with counterweight it may be covered over . Also on plate on dash on right side of throttle housing but just above the brake pedal If a B then you should be able to see it on the back side - look above the draw bar housing straight up
------------- Faith isn't a jump in the dark. It is a walk in the light. Faith is not guessing; it is knowing something. "Challenges are what make life interesting; overcoming them is what makes life meaningful."
|
Posted By: truckerfarmer
Date Posted: 15 Jul 2018 at 6:25am
On my HD5B it is on the right side about an inch down from the top. Straight back from where the linkage goes down into the housing next to the steering clutch cover.
------------- Looking at the past to see the future. '53 WD, '53 WD45, WD snap coupler field cultivator, #53 plow,'53 HD5B dozer
Duct tape.... Can't fix stupidity. But will muffle the sound of it!
|
Posted By: gemdozer
Date Posted: 15 Jul 2018 at 6:38am
Yes the serie number should be on right side but if you have a winch or ripper the serie number should be covert.
|
Posted By: dyno
Date Posted: 15 Jul 2018 at 1:18pm
Thanks guys! Hard to see with the winch in the way, HD5B 5764. Anyone know what year that makes it?
|
Posted By: DiyDave
Date Posted: 15 Jul 2018 at 6:38pm
Per CH Wendell's book, 1949
|
Posted By: dyno
Date Posted: 16 Jul 2018 at 8:25am
|