190XT Gas governor spring

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I think I need a governor spring for my 190XT gas. If I adjust the high idle according to the book, the low idle is too high (won't go to the stop on the carb). If I set it so it will go to low idle, then it will only rev to 2000 rpm. Called SLI and AGCO replaced the spring assembly (2 Parts) with 3 seperate parts and they are very proud of them. They now have an auxillary spring. Anyway I need a good spring if anyone has one. 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
DaveCinIN Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Orange Level Joined: 12 Sep 2009 Location: Kouts, IN Status: Offline Points: 356	Post Options Post Reply Quote DaveCinIN Report Post Thanks(0) Quote Reply Topic: 190XT Gas governor spring Posted: 20 Jul 2012 at 11:16pm
	I think I need a governor spring for my 190XT gas. If I adjust the high idle according to the book, the low idle is too high (won't go to the stop on the carb). If I set it so it will go to low idle, then it will only rev to 2000 rpm. Called SLI and AGCO replaced the spring assembly (2 Parts) with 3 seperate parts and they are very proud of them. They now have an auxillary spring. Anyway I need a good spring if anyone has one.

Sponsored Links

DrAllis Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 12 Sep 2009 Status: Offline Points: 2499	Post Options Post Reply Quote DrAllis Report Post Thanks(0) Quote Reply Posted: 21 Jul 2012 at 5:21pm
	If you have to, you can drill a new hole on the governor arm up 1/2" or so (from the original hole) to reach your high idle specs. It will require reworking the throttle cable anchor bracket just a bit to allow for a straight line, but that can be done easily.

DaveCinIN Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Orange Level Joined: 12 Sep 2009 Location: Kouts, IN Status: Offline Points: 356	Post Options Post Reply Quote DaveCinIN Report Post Thanks(0) Quote Reply Posted: 21 Jul 2012 at 9:39pm
	Thanks. I had a couple of ideas, but I like the redrilling better.

DaveCinIN Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Orange Level Joined: 12 Sep 2009 Location: Kouts, IN Status: Offline Points: 356	Post Options Post Reply Quote DaveCinIN Report Post Thanks(0) Quote Reply Posted: 10 Aug 2012 at 6:17pm
	Found a new governor spring assembly. Installed it and I now have both high and low idle at the proper rpm and the governor works just as it should.